Unit Converter

Type a value and choose units — results update instantly. Conversion factors follow SI and NIST definitions.

To
0.001
1 m = 0.001 km
1 m in all units
m1
km0.001
cm100
mm1,000
in39.3701
ft3.28084
yd1.09361
mi0.000621371

For educational and general reference only. Results depend on the accuracy of the values entered and are rounded to the selected precision. Verify critical designs with a qualified engineer and applicable codes. Full disclaimer

Concept and formula

Type a value and choose units — results update instantly. Conversion factors follow SI and NIST definitions. This converter changes a engineering quantity value from one recognized unit to another without changing the physical quantity it represents. The working relationship is converted value = source value × unit conversion factor. A conversion factor is a ratio of equivalent measurements, so multiplying by it replaces the original unit while preserving the measured amount.

Select the source and target units, enter a value, and read the converted result. The tool uses defined SI-based factors for scale conversions and the appropriate offset relationship for temperature. It also displays a comparison table, which is useful when several units must be checked at once. Swapping the units reverses the direction of conversion without changing the underlying method.

Conversion accuracy cannot exceed the accuracy of the original measurement. Choose significant figures that reflect the source data rather than reporting extra digits as if they were measured precision. Before using a converted value in design work, confirm that the selected units describe the same dimension and that any industry convention, nominal size, gauge, or local standard is handled separately.

Worked example

For example, select Length, enter 10 m, and convert to feet. Applying the selected SI conversion factor gives approximately 32.81 ft.

Frequently asked questions

How does the Unit Converter work?

It converts the entered engineering quantity value through its SI definition, then expresses the same quantity in the selected target unit.

Does the Unit Converter change the measured quantity?

No. A unit conversion changes only the numerical representation and unit label, not the physical amount.

How many significant figures should I use?

Use no more significant figures than the least precise source measurement. Extra displayed digits do not add measurement accuracy.

More general calculators