Flow Rate Calculator
Volumetric flow rate through a section equals the flow area times the mean velocity.
- Q = flow rate (m³/s)
- A = flow area (m²)
- v = mean velocity (m/s)
Result
For educational and general reference only. Results depend on the accuracy of the values entered and are rounded to the selected precision. Verify critical designs with a qualified engineer and applicable codes. Full disclaimer
Concept and formula
Volumetric flow rate through a section equals the flow area times the mean velocity. The governing relationship is Q = A × v. The symbols used are Q = flow rate (m³/s); A = flow area (m²); v = mean velocity (m/s). This equation expresses how the known quantities combine to produce the requested engineering result and supports transparent checking of the method.
For a reliable calculation, choose the unit beside each input and enter values that describe the same physical situation. The calculator converts compatible units internally before applying the formula, then lets you display the result in an appropriate unit. Its step-by-step working shows the substituted values and arithmetic, making unit mistakes or unexpected assumptions easier to spot. Keep all measurements consistent with the definitions shown above.
The result should be interpreted in the context of mechanical systems, machines, and equipment. Real designs can also depend on material properties, tolerances, losses, safety factors, boundary conditions, and applicable codes that are not represented by a single equation. Use sensible significant figures based on the accuracy of the inputs, and independently verify results used for safety-critical, contractual, or regulated work.
Worked example
Using Flow area = 10 cm², Mean velocity = 10 m/s, substitute the values into Q = A × v. The calculated result is Flow rate = 10 L/s.
Frequently asked questions
What formula does the Flow Rate Calculator use?
It uses Q = A × v. Q = flow rate (m³/s); A = flow area (m²); v = mean velocity (m/s).
Can I use different units in the Flow Rate Calculator?
Yes. Where unit selectors are shown, values are converted to compatible base units before the formula is evaluated.
How should I interpret the flow rate result?
Treat it as an engineering calculation based on the values entered. Match significant figures to your input accuracy and apply relevant design factors or standards separately.
